Trailer Guides & Bunks

Designed to supports bolster or bunk boards on boat trailers. 11 gauge steel brackets mount 2 inch bunks on edge. Slotted for vertical adjustment to standard or deep-V hulls. Hot dip galvanized for extra protection.

These 13-inch rubber rollers mount on top or beneath the frame for precise placement. The galvanized guide mount tubes can be adjusted up to 13 inches in width on each side. Brackets and hardware fit trailer frame rails up to 2 inches wide and 2 inch, 3 inch and 4 inch in height. Sold in pairs with all mounting hardware included.

The Tie Down Marine Bunk Board Guide-Ons are black, 2x4 carpeted bunk boards that are sold in pairs that will include all of the galvanized mounting hardware. The posts can be attached 5-11 inch on the side of the frame. If these posts are put above the frame, the bunk placement is 19 inches high. The U-bolts and nuts are plated in zinc. The kit frames 2-3 inches wide and 4 inches high.

Designed to absorb the impact of the hull and protect the boat's finish when loading for trailering. Heavy-duty galvanized steel frame provides full hull support. Roller bunks can be adjusted vertically with optional bolster support swivel brackets. Bunk kits do not include mounting hardware.

Pontoon trailer guides aid in loading the boat onto the trailer by raising up 12 inches when the trailer is submerged. Bright orange end caps on these PVC guides give you a brighter target when loading. These guides are designed to be mounted between the pontoons. Made of 1.5 inch square, 16 gauge steel galvanized tubing and covered by 2 inch x 20 inch PVC pipe. Mounts to trailer cross members 2 inch wide by 2, 3, or 4 inches high. All mounting hardware is included.

Heavy-duty, trailer-mounted guideposts are designed to assist in loading larger pontoon boats in rough water or high winds. Posts are hot dip galvanized 2.5 inch square steel, covered with molded PVC material. Designed to mount on the trailer between the pontoons. Mounts to trailer cross members 2 inches wide by 2-3 inches high. All mounting hardware is included.

Bright orange end caps on these PVC guides provide a bright, visible target when loading your pontoon boat. The guide posts are designed to be mounted between the pontoons. Made of 1-1/2 inch square, 16-gauge steel tubing and covered by 2 inch x 20 inch PVC pipe. Hot-dip galvanized guide posts extend fully into the PVC tube for additional strength. Mounts to trailer cross members up to 2 inches wide by 2 inches high. All mounting hardware included.

Tie Down marine bunk board guide-ons are black, 2x4 carpeted bunk boards that are sold in pairs that will include all of the galvanized mounting hardware. The posts can be attached 5-11 inches on the side of the frame. If these posts are put above the frame, the bunk placement is 19 inches high. The U-bolts and nuts are plated in zinc. The kit frames 2-3 inches wide and 4 inches high.

Non-marring PVC post helps guide the boat safely onto the trailer and gives a visual aid when backing an empty trailer. The 13-degree slant post provides a wider target when loading the boat. Metal bracing runs 15 inches into the pipe, adding strength and impact resistance. All mounting hardware included.

Designed to simplify loading Jon boats, bass boats, and personal watercraft onto boat trailers. The guide posts are made of 1.5 inch square, 16 gauge galvanized steel. The covers are made from high-impact non-marking molded PVC. Mounts to trailer cross members 2 inches wide and 2 to 4 inches high. All mounting hardware is included.